Silicon Electrical Steel
Mostrando 1-7 de 7 artigos, teses e dissertações.
-
1. Effect of Aluminium Addition on the Magnetic Properties of a Semi-Processed Electrical Steel
Aluminum is often added to electrical steels since this element causes improvement of the magnetic properties. However the addition of aluminum is usually limited to 0.30 wt%1. Therefore, this work aimed at evaluating the influence of higher levels of aluminum in the magnetic properties of semi-processed steels. To accomplish this, four types of steel were p
Mat. Res.. Publicado em: 12/09/2016
-
2. Performance of single wire earth return transformers with amorphous alloy core in a rural electric energy distribution system
In this paper are presented some considerations about the performance of single wire earth return amorphous alloy core transformers in comparison with conventional silicon steel sheets cores transformers used in rural electric energy distribution network. It has been recognized that amorphous metal core transformers improve electrical power distribution effi
Mat. Res.. Publicado em: 08/05/2012
-
3. Avaliação da influência dos parâmetros do processo de soldagem TIG sobre a qualidade de uma peça fabricada em aço elétrico silicioso / Influence of TIG welding process parameters on the quality of a piece fabricated with silicon electrical steel
The TIG welding process (Tungsten Inert Gas), also known as GTAW (Gas Tungsten ArcWelding), is the most commonly used process for welding of thin plates where there is a need for an excellent control of the temperature applied on the piece. This paper presents a study carried out in partnership between the Department of Graduate Studies in Scienceand Materia
Publicado em: 2010
-
4. Avaliação da influência da temperatura e ponto de orvalho no recozimento final de aços elétricos semiprocessados e totalmente processados / Evaluation of the influence of final annealing heat treatment temperature and dew point in semi-processed and fully processed electrical steels
Semi-processed electrical steels require annealing after processing in the motors manufactures to improve motors efficiency by reducing losses and increasing permeability. Annealing in fully processed electrical steel is performed to relax the residual stress and promote recovery or recrystallization of distorted parts. Commercial samples from different stee
Publicado em: 2010
-
5. Modelagem da precipitação de MnS em aços elétricos de grão orientado
Grain oriented silicon steel has been used for electrical purposes since the beginning of the twentieth century. Their properties such as high permeability and resistivity reduce energy losses. The high permeability of these steels arises from a preferred orientation of grains in relation to the direction of rolling which leads to strong anisotropy of the ma
Publicado em: 2010
-
6. Evolução da microestrutura e textura com a temperatura de acabamento de um aço GNO 1,3% Si
Silicon steels with non-oriented grain are used in a wide variety of applications, from small electrical machines, where high permeability is important, to large machines, where a low magnetic loss is the most important factor. The magnetic properties are determined, in large extent, by the final recrystallization texture produced, which is connected to the
Publicado em: 2005
-
7. Efeito da adição de carboneto de silício em pó na geração de microtrincas e na topografia da superfície na usinada por descargas elétricas do aço-rápido ABNT M2 / Effect of the addition of silicon carbide powder on the microcrack generation and on the surface topography in electrical discharge machining of ABNT M2 high speed steel,
This work investigates surface topography and microcrack generated by electrical discharge machining in workpieces of high speed steel (ABNT M2). Three different commercial dielectric fluids are used with and without addition of silicon carbide powder. Electrodes of electrolytic copper are used in roughing operations. The microcracks are evaluated using SEM
Publicado em: 1999