Nanocomposites Materials
Mostrando 1-12 de 81 artigos, teses e dissertações.
-
1. Zn2Al Layered Double Hydroxides Intercalated with Nitrate and p-Aminobenzoate as Ultraviolet Protective Agents in Low-Density Polyethylene Nanocomposites and Natural Insulating Oils
Zn2Al-Cl and Zn2Al-NO3 layered double hydroxides (LDHs) were synthesized through the fixed pH co-precipitation method and used as precursor materials for the intercalation of p-aminobenzoate through anion exchange reactions. Since chloride in Zn2Al-Cl was only partially exchanged with p-aminobenzoate, the phases Zn2Al-NO3 and Zn2Al-N -AB (nitrate exchanged w
J. Braz. Chem. Soc.. Publicado em: 2020-05
-
2. Characterization of TiO2 Nanoparticle’s Morphology and its Influence on the Hydrogen Sorption Kinetics of MgH2
TiO2 nanorods present good performance as catalysts in the sorption behavior of magnesium hydride. In the present study, the morphology of TiO2 nanorods produced from titanate nanotubes heat-treated at 550 °C (NR550), 650 °C (NR650) and 750 °C (NR750) was characterized and their catalytic role on the sorption kinetics of MgH2 was evaluated. For this, ball
Mat. Res.. Publicado em: 20/12/2019
-
3. GRAPHENE OXIDE AND A GO/ZnO NANOCOMPOSITE AS CATALYSTS FOR EPOXY RING-OPENING OF EPOXIDIZED SOYBEAN FATTY ACIDS METHYL ESTERS
Abstract In this work, the grapheme oxide (GO) and GO/ZnO nanocomposite were successfully obtained from the oxidation of graphite and characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), and thermogravimetric analysis (TGA). In the GO/ZnO nanocomposite, the GO sheets were coated with aggregated
Braz. J. Chem. Eng.. Publicado em: 09/12/2019
-
4. Single-Walled Carbon Nanotubes/Poly Vinyl Chloride Nanocomposites and its Properties
ABSTRACT The SWNTs was purified/functionalized by acid treatment method and the F-SWNTs were used as reinforcing materials. The acid treatment introduced carboxyl (–COOH) group to the SWNTs. The PVC and F-SWNTs/PVC films were prepared by solution casting method. The fractured surfaces of sample was analyzed through SEM and showed the dispersion of F-SWNTs
Matéria (Rio J.). Publicado em: 25/11/2019
-
5. Materials from renewable resources: new properties and functions
Abstract: Sustainable production requires increasing use of raw materials from renewable sources, processed under mild conditions with minimal effluent production. These requirements are satisfied by using materials derived from biomass, in synergy with food and energy production. The possibilities of biomass are continuously enlarged by new findings, as in
An. Acad. Bras. Ciênc.. Publicado em: 21/10/2019
-
6. Gold Nanoparticles and [PEDOT-Poly(D,L-Lactic Acid)] Composite: Synthesis, Characterization and Application to H2O2 Sensing
Biocompatible electrochemical devices are challenging to develop due to the toxicity of many advanced electrode materials and the difficulty to degrade the discarded material. Few recent advances were made in the synthesis of conducting biodegradable composites of polymers for electrode materials. In this article we describe the synthesis of two new inorgani
J. Braz. Chem. Soc.. Publicado em: 21/10/2019
-
7. Gamma irradiation effects on polycaprolactone/zinc oxide nanocomposite films
Abstract Polycaprolactone (PCL) to which has been added zinc oxide nanoparticles (ZnO NPs) produces nanocomposites (PCL/ZnO NCs). These nanocomposites can be used in biomedical applications and in the food packaging sector. However, for these materials to be used in these applications, they need to be sterilized. For this, gamma irradiation is the most comm
Polímeros. Publicado em: 21/03/2019
-
8. Evaluation of the dispersion of carbon nanotubes in an elastomeric polyurethane and fatigue test
Abstract Two series of polyurethane (PU) and carbon nanotubes (CNT) based composites with 0.0, 0.25, 0.5 and 1.0 mass% of CNT were obtained from diluting a commercial masterbatch with 30 mass% CNT and using two different dispersion methods. The quality of the dispersions was assessed using optical microscopy, and scanning and transmission electron microscop
Polímeros. Publicado em: 18/03/2019
-
9. Structural, Morphological and Magnetic Properties of FeCo-(Fe,Co)3O4 Nanocomposite Synthesized by Proteic Sol-Gel Method Using a Rotary Oven
FeCo nanoparticles coated with (Fe,Co)3O4 (magnetite doped with cobalt) were synthesized by the proteic sol-gel chemical route. The synthesized materials were characterized by Thermogravimetry (TG), X-Ray Diffraction (XRD), Scanning Electron Microscopy (SEM), Transmission Electron Microscopy (TEM), vibrating-sample magnetometer (VSM) and Mössbauer spectrosc
Mat. Res.. Publicado em: 18/03/2019
-
10. Matéria Evaluation of zinc oxide nanoparticles influence on hydrophilic polymer matrix systems
ABSTRACT Hydrophilic polymer matrix systems (HPMSs) are a highly relevant tool for drugs delivery whose bioavailability is impaired by low hydrosolubility. Besides this, when associated with nanoparticles these systems can provide better control over release profile of the active drug, maintaining the posology. Since polyvinylpyrrolidone (PVP) and zinc oxide
Matéria (Rio J.). Publicado em: 06/12/2018
-
11. Nanocomposite Films Based on Flaxseed Gum and Cellulose Nanocrystals
Flaxseed gum (FG)-based films were developed with the addition of glycerol as a plasticizer and glutaraldehyde as a crosslinking agent. HCl was added to improve crosslinking and decrease the hydrophilicity of the matrix. Different cellulose nanocrystal (CN) amounts were used as reinforcements in the optimum FG formulation. The crosslinking process at pH 3.5
Mat. Res.. Publicado em: 22/10/2018
-
12. Effect of the Morphology and Structure on the Microwave Absorbing Properties of Multiwalled Carbon Nanotube Filled Epoxy Resin Nanocomposites
The current research shows the effect of structural and morphological differences of multilayer carbon nanotubes (CNT) on radar absorbing materials (RAM) performance. Two CNT samples, from different manufacturers, had their morphological and structural aspects investigated by XRD, SEM and SEM-FEG analyses. CNT/epoxy resin based nanostructured composites were
Mat. Res.. Publicado em: 16/07/2018