Effect of surface roughness and lubrication on the friction coefficient in deep drawing processes of aluminum alloy aa1100 with fem analysis
AUTOR(ES)
Folle, Luis Fernando
FONTE
Matéria (Rio J.)
DATA DE PUBLICAÇÃO
16/09/2019
RESUMO
ABSTRACT Friction between the interface workpiece and tooling has considerable importance in sheet metal forming operations; an accurate description of the friction is necessary to analyze and design new workpieces and tooling. This work suggests a methodology to determine and evaluate the mean coefficient of friction (COF) using the Finite Element Method (FEM) through Dynaform for the aluminum alloy AA1100. The results indicate that this methodology is consistent with reality. It is also observed that the software tends to diverge from the measured results because the software considers the COF to be constant along the process. Despite this trend, the greatest distance between the maximum drawing force given by the measurement and the numeric simulation was not high: it was approximately 6%. Workpiece strain measurements were collected to compare with the numerical simulation results, and it was observed that they are generally in agreement.
Documentos Relacionados
- Effect of surface roughness and lubrication on the friction coefficient in deep drawing processes of aluminum alloy aa1100 with fem analysis 1
- Effect of casting mode and thermal treatments on the electrical conductivity of the AA4006 aluminum alloy
- Corrosion behavior of friction stir welded lap joints of AA6061-T6 aluminum alloy
- Effect of surface finishing on friction and wear of Poly-Ether-Ether-Ketone (PEEK) under oil lubrication
- Effect of Scanning Speed on the Surface Roughness of Laser Metal Deposited Copper on Titanium Alloy