Tin Linear
Mostrando 1-12 de 26 artigos, teses e dissertações.
-
1. Determination of 3,4,5-Trihydroxybenzoic Acid Exploiting a Visible-Light-Driven Photoelectrochemical Platform: Application in Wine and Tea Samples
The present work is based on the development and application of a photoelectrochemical method for the amperometric determination of 3,4,5-trihydroxybenzoic acid in different samples. The method is based on the use of a photoelectrochemical platform based on a glass slide coated with fluorine-doped tin oxide, which has been modified with cadmium sulfide and p
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
2. Light-Assisted Batch Injection Analysis of Glucose Exploiting a p-n-Homojunction Based on Cu2O
This work describes the development of a photoelectrochemical sensor for glucose quantification exploiting a light assisted-batch injection analysis (BIA) cell. A light-emitting diode (LED) lamp was employed to control the incidence of light on the p-Cu2O/n-Cu2O/fluorine-doped tin oxide (FTO) photoactive platform in BIA cell. The p-Cu2O/n-Cu2O/FTO platform w
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
3. Gold Nanoparticle/Tetrapyridylporphyrin Hybrid Material: Spectroscopic and Electrocatalytic Properties and Sensor Application
An electrocatalytic active hybrid material prepared by successive stepwise coordinative deposition of 20 nm diameter gold nanoparticles (AuNP) with 5,10,15,20-tetra(4-pyridyl)-21H,23H-porphine (TPyP) on fluorine-doped tin oxide (FTO) substrates previously modified with 3-mercaptopropylsilane is described. Their interaction and assembly were studied by UV-Vis
J. Braz. Chem. Soc.. Publicado em: 2020-11
-
4. Ações contra a Covid-19 na População com Síndrome de Down
An electrocatalytic active hybrid material prepared by successive stepwise coordinative deposition of 20 nm diameter gold nanoparticles (AuNP) with 5,10,15,20-tetra(4-pyridyl)-21H,23H-porphine (TPyP) on fluorine-doped tin oxide (FTO) substrates previously modified with 3-mercaptopropylsilane is described. Their interaction and assembly were studied by UV-Vis
Arq. Bras. Cardiol.. Publicado em: 2020-11
-
5. Comparison Between Three Chromatographic (GC-ECD, GC-PFPD and GC-ITD-MS) Methods and a UV-Vis Spectrophotometric Method for the Determination of Dithiocarbamates in Lettuce
The purpose of this study was to compare the performance of gas chromatographic with electron capture detector, pulsed flame photometric detector and mass spectrometry (GC-ECD, GC-PFPD and GC-MS) and UV-Vis spectrophotometric methods, based on acidic hydrolysis with tin(II) chloride of dithiocarbamate and analysis of the evolved CS2. For the validation studi
J. Braz. Chem. Soc.. Publicado em: 2017-05
-
6. Effects of Measurements Conditions on an Extended-Gate FET used as pH sensor
Fluorine-doped tin oxide (SnO2:F) was investigate as the sensitive part of a pH sensor in the extended-gate field effect transistors (EGFET) device, which provided a linear response for pH range from 2 to 12; the sensitivity was 37 mV.pH-1 for experiments performed in absence of light. Neutral pH, leads to a transistor’s electric current remained practical
Mat. Res.. Publicado em: 05/02/2016
-
7. Ultrafast Dynamics of Au Nanopyramid Interfaces Prepared by Nanosphere Lithography: Effect of Substrate Chemical Composition
This work describes ultrafast spectroscopy studies of Au triangular pyramid particle arrays deposited over glass (termed Au/glass), and 190 nm indium tin oxide (ITO) film (termed Au/ITO/glass) prepared by nanosphere lithography. The linear absorption spectra of Au/glass and Au/ITO/glass exhibit surface plasmon resonances at 800 and 870 nm, respectively, in g
J. Braz. Chem. Soc.. Publicado em: 2016-02
-
8. Consistência hidrológica de modelos digitais de elevação (MDE) para definição da rede de drenagem na sub-bacia do horto florestal Terra Dura, Eldorado do Sul, RS
O desenvolvimento da erosão hídrica ocorre em resposta ao modo como a água se move através e sobre uma determinada paisagem. O modelo digital de elevação (MDE) deve, portanto, ser o mais preciso possível, uma vez que constitui a base para a análise do relevo. Este trabalho teve como objetivo definir um modelo digital de elevação hidrologicamente co
Rev. Bras. Ciênc. Solo. Publicado em: 2012-08
-
9. MÉTODOS INDIVIDUAL E MULTIRRESIDUAL PARA DETERMINAÇÃO DE PESTICIDAS EM GRÃOS E DERIVADOS POR GC-PFPD, GC-ITD-MS E LC-MS/MS / SINGLE AND MULTI-RESIDUE METHODS FOR PESTICIDE ANALYSIS IN GRAINS AND DERIVATES BY GC-PFPD, GC-ITD-MS AND LC-MS/MS
Due to the complexity of grains like soybean, corn and rice, and the very low pesticide concentration expected for these samples, it is really necessary to develop efficient and reliable analytical methods to identify and quantify their residues. The possibility to perform the determination of a large number of pesticides in just a single chromatographic ana
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 29/08/2011
-
10. Estudo e aplicação das propriedades elétricas, térmicas e mecânicas de materiais amorfos piezoresistivos em transdutores de pressão. / Study and application of eletrical properties, thermal and mechanical of amorphus matherials in piezoresistive.
This tesis presents the piezoresistivity theoretical and experimental study for two materials with amorphous structure. The first material is the Diamond Like Carbon and the other is the Indium Tin Oxide. The work includes the bibliographic study, theoretical and practical design of structures for testing individual and piezoresistors configured in bridge, i
Publicado em: 2009
-
11. O plÃsmon da regiÃo de recobrimento da ligaÃÃo quÃmica como ferramenta para caracterizaÃÃo de materiais
Important issues can be raised about the possibility of relations between macroscopic properties of materials and concepts, introduced recently, of the chemical bond overlap polarizability (PR) and the concept of ionic specific valence (VIE). A proposal in which the overlap region of chemical bond is considered as a âplasmon‐likeâ charge distribution
Publicado em: 2009
-
12. Estudo da obtenção e das propriedades dos filmes de TiN e TiC depositados sobre aços ferramentas AISI H13 e D2 nitretados e não nitretados. / Study of the making and properties TiC and TiN coatings deposited on AISI H13 and AISI D2 toll nitrated and not nitrated steel.
Filmes de nitreto de titânio e carbeto de titânio foram obtidos por deposição reativa via magnetron sputtering, utilizando como gases reativos, nitrogênio e metano, respectivamente. Foram depositados filmes de TiN e TiC, primeiramente sobre substratos de aços ferramenta AISI H13 e AISI D2 temperados e revenidos. Posteriormente, realizou-se o tratamento
Publicado em: 2008