Thermal Parameters
Mostrando 1-12 de 695 artigos, teses e dissertações.
-
1. Tailoring the properties of Y2O3 via synthesis parameters varied during the PVA-assisted sol-gel route
Abstract The effect of synthesis parameters on the microstructural behavior and morphology during the yttrium oxide (Y2O3) formation is reported. Y2O3 crystals were produced by a modified sol-gel route assisted by polyvinyl alcohol solution varying the calcination temperature and solution pH. The crystalline phase formation was investigated using X-ray powde
Cerâmica. Publicado em: 2023
-
2. Quality Control for Lignin and Gelatin Microcapsules Loaded with Orange Essential Oil
Sustainable natural product-based microstructured systems and biopolymers are strong candidates for use in crop protection. Lignin and gelatin microcapsules loaded with orange essential oil were developed with spray-drying in order to enhance its potential. We evaluated the microparticle controlled release mechanisms, biological effects, structural and therm
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
3. Thermal Infrared Enthalpimetry Method for the Determination of Hypochlorite in Bleaching Solutions
Thermal infrared enthalpimetry (TIE) was used for hypochlorite determination in commercial hypochlorite-based bleaching solutions. Experimental parameters were evaluated for the reaction with a hydrogen peroxide solution. The most relevant conditions were 5% H2O2 (m/m) solution, stirring speed of 250 rpm, dispensing rate of 0.57 mL s-1, and 10 s after reacti
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
4. Numerical simulations of ceramic firing in catenary kilns
Abstract Kiln geometries were developed to reach homogeneous temperatures above 900 °C, during the firing process, aiming to improve the production process of the ceramists from Vale do Jequitinhonha (MG/Brazil). Techniques of reactive flow numerical solution using the software Ansys CFX have been used to foresee the behavior of the firings. Two types of ca
Cerâmica. Publicado em: 2022
-
5. Thermal, structural and optical properties of magnetic BiFeO3 micron-particles synthesized by coprecipitation method: heterogeneous photocatalysis study under white LED irradiation
Abstract Bismuth ferrite, BiFeO3 (BFO) prepared via a coprecipitation method, was used as an effective photocatalyst for the degradation of methylene blue (MB) using a white light-emitting diode (LED-50 W) lamp. The as-prepared material was characterized by TGA, XRD, SEM-EDX, FTIR, and UV-vis-DRS techniques. The effects of experimental key parameters such as
Cerâmica. Publicado em: 2022
-
6. The importance of education
Abstract The present research is dedicated to analyzing the addition of sawdust biomass, which is a carbonaceous raw material that may be used in coal blends for the production of metallurgical coke, preserving the required quality, with lower cost. The quality of metallurgical coke may be determined by the efficiency of its chemical, physical and thermal fu
REM, Int. Eng. J.. Publicado em: 2021-06
-
7. Quality evaluation of metallurgical coke produced with sawdust and different mixtures of coal
Abstract The present research is dedicated to analyzing the addition of sawdust biomass, which is a carbonaceous raw material that may be used in coal blends for the production of metallurgical coke, preserving the required quality, with lower cost. The quality of metallurgical coke may be determined by the efficiency of its chemical, physical and thermal fu
REM, Int. Eng. J.. Publicado em: 2021-06
-
8. Fatty acid profile and physicochemical, optical and thermal characteristics of Campomanesia adamantium (Cambess.) O. Berg seed oil
Abstract The aim of this study was to characterize the oil obtained from seeds of Campomanesia adamantium by physicochemical quality parameters, oxidative stability, antioxidant activity, quality indexes, optical and thermal stability and its fatty acid profile. These seeds were a relevant source of oil (83 mg g-1) with high potential antioxidant activity (I
Food Sci. Technol. Publicado em: 2020-12
-
9. Kinetic Parameters of the Thermal Oxidation and Degradation Reactions in Soybean Oil and Palm Olein
Partially hydrogenated soybean oil and palm olein are oils that are widely used in the food industry. Continuous contact with air may cause changes of the triglycerides chemical structure, to eventually produce substances of lower molar masses that may be toxic to mammals. This study aimed to determine the kinetic parameters for the thermal oxidation of thes
J. Braz. Chem. Soc.. Publicado em: 2020-10
-
10. Is it still worth Publishing Case Reports? They are Part of our Lives
Partially hydrogenated soybean oil and palm olein are oils that are widely used in the food industry. Continuous contact with air may cause changes of the triglycerides chemical structure, to eventually produce substances of lower molar masses that may be toxic to mammals. This study aimed to determine the kinetic parameters for the thermal oxidation of thes
Braz. J. Cardiovasc. Surg.. Publicado em: 2020-10
-
11. Study using a CFD approach of the efficiency of a roof ventilation closure system in a multi-tunnel greenhouse for nighttime microclimate optimization
ABSTRACT The thermal efficiency of naturally ventilated greenhouses is limited due to the permanent exchange of air through the vents, especially during the night hours. The objective of the work consisted in evaluating a system of inflatable air ducts that close the roof vents during the night as a strategy to reduce the energy loss during these hours. For
Rev. Ceres. Publicado em: 2020-10
-
12. A New Energetic Complex: Synthesis, Structure, and Combustion Catalysis Performance
The potential of tetrazole-based ligands for forming energetic complexes applied in pyrotechnics and propellants is demonstrated with the use of 5,5’-(1,3-phenylene)bis(1H-tetrazole) (H2BTB) to generate an energetic complex with high energy. A new energetic complex of PbII-tetrazolate, [Pb2(BTB)2(H2O)8]·5H2O (1), was synthesized and structurally character
J. Braz. Chem. Soc.. Publicado em: 2020-08