Steel Fiber Reinforced Concrete
Mostrando 1-12 de 46 artigos, teses e dissertações.
-
1. Uma abordagem experimental e numérica para determinação de curvas de compressão para concreto simples e reforçados com fibras de aço
RESUMO A curva tensão-deformação do concreto é importante para o dimensionamento de estruturas, pois por meio dela é possível obter sua resistência à compressão, sua deformação de pico, o módulo de elasticidade e a tenacidade do concreto. Entretanto, essa é uma propriedade que não é comumente determinada nos ensaios de controle de qualidade do
Matéria (Rio J.). Publicado em: 16/09/2019
-
2. An Anchorage System for Enhanced Bond Behavior between Carbon Fiber Reinforced Polymer Sheets and Cracked Concrete
Abstract The contribution of CFRP wraps, as an anchorage system, to enhancing bond behavior between CFRP sheet and cracked concrete, was investigated. Thirty six concrete blocks (150 x 150 x 200 mm) were cast with 3ϕ12 mm steel bars embedded laterally at different spacing along the 200-mm-dimension. Half of the moist-cured blocks were subjected to a cyclic
Lat. Am. j. solids struct.. Publicado em: 05/09/2019
-
3. Avaliação do grau de orientação de fibras de aço induzida na moldagem de elementos planos com concreto autoadensável
RESUMO O uso de concreto autoadensável (CAA) aliado ao concreto reforçado com fibras (CRF) tem sido objeto de várias pesquisas recentes. A combinação da fluidez do CAA com o uso de fibras aumenta a probabilidade de que, no processo de lançamento, seja possível causar orientação preferencial nas fibras, inclusive em elementos planos. Isto pode ser be
Matéria (Rio J.). Publicado em: 10/06/2019
-
4. Experimental studies of short concrete reinforced steel fiber beams under bending
Resumo Este estudo apresenta os resultados do rompimento de dois grupos de vigas de concreto com fibras de aço. Cada grupo foi composto de 4 vigas com vão de 300 mm, 4 com vão de 500 mm e 4 com vão de 800 mm e seção de 15 cm x 15 cm. A variação dos grupos se deu pela quantidade de fibras (I com 40 kg/m³ e II com 60 kg/m³). Foram avaliados o comport
Rev. IBRACON Estrut. Mater.. Publicado em: 20/05/2019
-
5. Analyses of reinforced concrete beams strengthened with CFRP under bending: theorical and computational approaches
Resumo Este trabalho tem como objetivo compilar o embasamento teórico do ACI 440.2R:2008 [1] com o da NBR 6118:2014 [2] a fim de levar em consideração os conceitos da norma brasileira no dimensionamento à flexão de vigas reforçadas com PRFC (Polímeros Reforçados com Fibra de Carbono). A contribuição da norma brasileira é dada particularmente no qu
Rev. IBRACON Estrut. Mater.. Publicado em: 20/05/2019
-
6. Experimental analysis of load capacity in beams with steel fiber reinforcement on the compression face
Resumo A utilização de fibras de aço no concreto visa aumentar principalmente a tenacidade, em função da aderência das fibras à matriz cimentícia. Entretanto como existem diversas tipologias de fibras de aço, as principais diferenças estão no fator de forma (relação entre comprimento e diâmetro), na geometria das fibras, e, na caracterização
Rev. IBRACON Estrut. Mater.. Publicado em: 2019-02
-
7. Monitoreo mediante Emisión Acústica de vigas de hormigón de alta resistencia con y sin fibras expuesto a alta temperatura
ABSTRACT The addition of fibers to the cementitious matrix, giving rise to fiber-reinforced concrete, aims to improve the low ductility observed in concrete mechanical response under different load scenarios, particularly under direct tension. In this work, cracking and mechanical degradation processes of concrete elements using acoustic emission technique a
Matéria (Rio J.). Publicado em: 19/07/2018
-
8. Experimental analysis of the efficiency of steel fibers on shear strength of beams
Abstract The efficiency of steel fibers for shear strength of reinforced concrete beams is assessed. Four beams were evaluated: control consisted of one beam without any steel fibers and three beams with reinforced concrete with steel fibers. All beams were reinforced for shear strength by a minimum reinforcement rate. The influence of fiber content added to
Lat. Am. j. solids struct.. Publicado em: 16/07/2018
-
9. Structural Behavior of RC Beams Containing a Pre- Diagonal Tension Crack
Abstract This study focuses the light on the shear behavior of pre-cracked beams, and examines the feasibility of applying fracture mechanics concepts to widen the understanding of shear behavior and mechanisms. The experimental program contains ten beam specimens of high strength concrete (HSC) and steel fiber reinforced concrete (SFRC). Pre-cracks were emb
Lat. Am. j. solids struct.. Publicado em: 16/07/2018
-
10. Mechanical behaviour of steel fiber reinforced concrete with stone powder
ABSTRACT Nowadays, there is an increasing interest in the development of eco-friendly materials. Thus, environmental challenges due to the necessity of reducing worldwide levels of CO2 emissions, to limit the energy consumption and to use industrial waste are promoting an increasing effort to find viable alternatives to minimize pollution from the main produ
Matéria (Rio J.). Publicado em: 20/07/2017
-
11. Structural Behavior of SFRC Beams strengthened with GFRP Laminates: An Experimental and Analytical Investigation
ABSTRACT This paper presents the experimental results of a reinforced concrete beams (RC) strengthened with internal steel fibers (SF) and external glass fiber reinforced polymer laminates (GFRP). The research work studied the load carrying capacity, deformation, crack width and ductility of the reinforced concrete beams strengthened with different steel fib
Braz. arch. biol. technol.. Publicado em: 23/01/2017
-
12. Strain Rate Dependent Behavior and Modeling for Compression Response of Hybrid Fiber Reinforced Concrete
Abstract This paper investigates the stress-strain characteristics of Hybrid fiber reinforced concrete (HFRC) composites under dynamic compression using Split Hopkinson Pressure Bar (SHPB) for strain rates in the range of 25 to 125 s-1. Three types of fibers - hooked ended steel fibers, monofilament crimped polypropylene fibers and staple Kevlar fibers were
Lat. Am. j. solids struct.. Publicado em: 2016-09