Optical Gain
Mostrando 1-12 de 71 artigos, teses e dissertações.
-
1. MGF Methods for Fixed and Gain Saturated Optically Preamplified FSO Links Impaired by Misalignments and Atmospheric Turbulence
Abstract The Gaussian approximation is commonly used to evaluate the performance of free space optical communication systems. However, other performance evaluation methods such as the saddle point approximation, Chernoff bound and the modified Chernoff bound have also been used. This paper investigates the performance of fixed and gain saturated optically pr
Journal of Microwaves, Optoelectronics and Electromagnetic Applications. Publicado em: 2022
-
2. Design and Simulation of Broadband Horn Nanoantennas for Nanophotonic Applications
Abstract Optical plasmonic nanoantennas have proven useful in nanoplasmonic applications, paving the way for more efficient wireless optical communications. In this work, we propose a parametric study of a plasmonic horn nanoantenna in flat H sectorial format and beveled horn, both designed to radiate in the three wavelengths of optical communications: [850
Journal of Microwaves, Optoelectronics and Electromagnetic Applications. Publicado em: 2022
-
3. Study and Optimization of Raman Amplifiers in Tellurite-Based Optical Fibers for Wide-Band Telecommunication Systems
Abstract Here we present a numerical analysis and the optimization of a multi-pump discrete Raman amplification system based on the use of a Tellurite optical fiber as the gain media. By using previously reported optimization techniques we were able to exploit the high Raman gain of Tellurite optical fibers and its multipeak spectrum to achieve amplification
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 19/06/2019
-
4. Synthesis and characterization of nanostructured TiO2 and TiO2/W thin films deposited by co-sputtering
ABSTRACT Nanostructured TiO2 and TiO2/W thin films were deposited on Corning glass substrates by RF and DC magnetron co-sputtering at room temperature, using three targets of TiO, Ti and W. After deposition, samples were subjected to an annealing treatment in air at 500 °C for 3 hrs. The effect of the annealing treatment and tungsten addition to the TiO2 ma
Matéria (Rio J.). Publicado em: 19/07/2018
-
5. Calibration of TLM Model for Semiconductor Optical Amplifier by Heuristic Parameters' Extraction
Abstract The systemic behavior of a Semiconductor Optical Amplifier model was optimized through extensive simulations, reaching reasonable approximation to experimental obtained from commercial devices for the optical gain versus bias current, for different optical inputs powers (-25 up to 0 dBm), and for the gain saturation profile for different I-bias (0 u
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2018-06
-
6. A simple strategy to design broadband low power consumption distributed Raman amplifier
Abstract In this work, a simple strategy to design wideband low power consumption Raman amplifiers is demonstrated for a three-pump configuration using a low water peak optical fiber. The approach is based on the introduction of a novel numerical measure, which quantifies and isolates pump-pump interaction contribution to gain profile and analyzes its correl
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2017-09
-
7. EDFA Design and Analysis for WDM Optical Systems Based on Modal Multiplexing
Abstract Modal multiplexing (MDM) is a core technology to allow a capacity increase in modern optical systems. However, in MDM links, the amplified WDM signal suffers not only from lack of spectral gain equalization but also from unequal modal gain. The proper design of the MDM-EDFA is crucial to provide modal gain equalization and to overcome those impairme
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2017-03
-
8. Experimental-based subsystem models for simulation of heterogeneous optical networks
This work presents and analyzes experimental-based subsystem models for Erbium doped fiber amplifiers (EDFAs) and wavelength selective switches (WSSs) under operation in a metropolitan optical network testbed. Firstly, the performance of the EDFAs and two gain control types are analyzed in a heterogeneous experimental setup with lightpaths modulated at 10G/1
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2014-12
-
9. Hybrid distributed Raman/EDFA amplifier with hybrid automatic gain control for reconfigurable WDM optical networks
Nowadays, optical amplifiers designs are induced by new requirements generated by optical networks. The introduction of WDM reconfigurable networks with increasing rate from 10-40 Gb/s to 100 Gb/s and beyond, demand new optical amplifiers development with improved gain spectral flatness and noise figure for all operational range of input powers and set-point
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2013-12
-
10. Comparing OSNR based policies for an adaptive-alternative IA-RWA algorithm applied to all-optical networks
We propose two policies to select the route for an adaptive-alternative routing algorithm for all-optical networks. We use the NrPSR to find the Nr routes with lower cost for a given source-destination pair according to a cost function expanded in a power series (PSR) in which the coefficients are determined by a Particle Swarm Optimizer (PSO). The selected
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2013-12
-
11. Influência do pH e da irradiação em filmes biodegradáveis de proteínas do soro de leite / Influence of ph and irradiation in whey proteins biodegradable films
The packaging has as main function to maintain the integrity of the product, protecting it against mechanical damage, moisture loss and gain. Most packaging is manufactured from non-biodegradable materials and non-renewable source promoting great environmental impacts. Among the raw materials used in the development of biodegradable films found the whey prot
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 24/02/2012
-
12. Performance analysis of peak tracking techniques for fiber Bragg grating interrogation systems
In this paper, we propose a spectral correlation-based technique for tracking the wavelength shift of a fiber Bragg grating. We compared this approach, by means of a Monte Carlo numerical simulation, to the typical peak tracking techniques applied in classic interrogation systems. As result, we obtained a considerable gain in terms of noise tolerance (about
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2012-12