Nanostructured Particles
Mostrando 1-12 de 35 artigos, teses e dissertações.
-
1. Impact of fuel quantity on luminescence properties of Sr3Al2O6:Eu by combustion synthesis
Abstract The photoluminescent behavior of Eu-doped Sr3Al2O6 obtained by highly efficient solution combustion synthesis is reported. In order to understand the influence of the fuel on the synthesis, the stoichiometric quantity and an excess of fuel were evaluated. By adjusting the amount of fuel, different luminescence responses were obtained, allowing europ
Cerâmica. Publicado em: 2023
-
2. Antimicrobial High-Density Polyethylene (HDPE)/ZnO Nanocomposites Obtained by in situ Polymerization
Nanostructured zinc oxide (ZnO) prepared by combustion in solution was used to obtain nanocomposites. The ZnO particles were characterized by Brunauer-Emmett-Teller (BET), X-ray diffraction (XRD), and scanning electron microscopy (SEM), showing crystallite size of 32 nm and a superficial area of 32.6 m2 g-1. Nanocomposites with 1, 3, and 5 wt.% of ZnO in the
J. Braz. Chem. Soc.. Publicado em: 2020-08
-
3. Nanostructured polymeric system based of cashew gum for oral admnistration of insulin
ABSTRACT The subcutaneous administration of insulin has been the treatment of millions of diabetics in the world. However, for such via insulin is invasive and not mimics the physiological action causing side effects. The oral route would be the most physiological and comfortable option, but the oral bioavailability of insulin is low by proteolytic activity
Matéria (Rio J.). Publicado em: 16/09/2019
-
4. Colombian propolis as starting material for the preparation of nanostructured lipid carriers
ABSTRACT The value of propolis is scientifically and commercially measured through the content of biologically active molecules as phenolic compounds and flavonoids; on the other hand, a high percentage of waxes in the propolis composition makes it a substandard beekeeping product. Colombian propolis is characterized by a high content of waxes; however, this
Rev. bras. farmacogn.. Publicado em: 26/08/2019
-
5. Analysis of Styrene Polymerization Without Surfactant and N2 Gas in Cylindrical Flask.
The conditions of chemical synthesis can be crucial for polymerization of styrene in such a way that it can be produced latex beads at nanometric range (ϕ < 400nm). In this work, it will be analyzed how the absence of N2 and surfactant will result in colloidal particles with high affinity to agglomerate forming two kinds of nanostructured assemblies: colloi
Mat. Res.. Publicado em: 22/01/2018
-
6. Temperature and Deposition Time Effect on Properties and Kinetics of CdSe and CdS0.25Se0.75 Films Deposited by CBD
CdSe and CdS0.25Se0.75 thin films were grown by the Chemical Bath Deposition technique at different temperatures (50-90°C) and deposition times (5-180 min). Both kinds of films are polycrystalline, constituted by nanostructured clusters of particles. CdSe films consist in a mixture of cubic and hexagonal phases (4-8 nm crystal size), whereas only the hexago
Mat. Res.. Publicado em: 26/06/2017
-
7. Histomorphometric evaluation of strontium-containing nanostructured hydroxyapatite as bone substitute in sheep
Abstract The aim of this study is to evaluate the biocompatibility and osteoconductivity in surgical defects of sheep tibias filled with 1% strontium-containing nanostructured hydroxyapatite microspheres (SrHA), stoichiometric hydroxyapatite without strontium microspheres (HA), or blood clots. Santa Ines sheep were subjected to three perforations on the medi
Braz. oral res.. Publicado em: 06/05/2016
-
8. Cytocompatibility and biocompatibility of nanostructured carbonated hydroxyapatite spheres for bone repair
ABSTRACT Objective The aim of this study was to investigate the in vitro and in vivo biological responses to nanostructured carbonated hydroxyapatite/calcium alginate (CHA) microspheres used for alveolar bone repair, compared to sintered hydroxyapatite (HA). Material and Methods The maxillary central incisors of 45 Wistar rats were extracted, and the den
J. Appl. Oral Sci.. Publicado em: 2015-12
-
9. Hidrogeles microestructurados de acrilamida y determinación de su capacidad de absorber agua y etanol
This paper reports the synthesis of nanostructured hydrogels of acrylamide by a two-step polymerisation process. The first step is performed by inverse microemulsion polymerization (water-in-oil) of N-isopropylacrylamide (NIPA), with these particles then added to aqueous solutions of acrylamide (AM), adding a crosslinking agent. The polymerization reaction i
Quím. Nova. Publicado em: 2013
-
10. Nanostructured MgH2 obtained by cold rolling combined with short-time high-energy ball milling
MgH2 was processed by short time high-energy ball milling (BM) and cold rolling (CR). A new alternative processing route (CR + BM) using the combination of CR followed by short time BM step was also applied. The effects on the final morphology, crystalline structure and H-sorption properties were evaluated. The CR + BM processing (compared to BM and CR proce
Mat. Res.. Publicado em: 22/11/2012
-
11. Efeito de metais de transição sobre a polarização espontânea na estrutura cristalina de nanopós da família tungstênio bronze
This work aimed the study of the effect of transition metals (Ni, Fe, Co) on the spontaneous polarization of the ferroelectric oxides of tetragonal tungsten bronze (TTB)-type structure of potassium strontium niobate (KSr2Nb5O15) and of the KSr2(FeNb4)O15-d, KSr2(NiNb4)O15-d and KSr2(CoNb4)O15-d solid solutions. All systems investigated were prepared by mecha
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 28/02/2011
-
12. Estudo da atividade fotocatalítica de nanotubos de TiO2 dopados com nitrogênio
This work presents the study of the catalytic performance of nanostructured titanium oxide, TiO2, doped with nitrogen in order to improve its photocatalytic activity under visible light. TiO2 nanotubes were prepared by hydrothermal method, where TiO2 particles react with NaOH at high temperature and pressure. Then the material was handled through an acid was
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 2011