Heat Exchanger
Mostrando 1-12 de 125 artigos, teses e dissertações.
-
1. Influence of a heat and moisture exchanger with a microbiological filter on measurements of maximal respiratory pressures and vital capacity in patients with COPD
J. bras. pneumol.. Publicado em: 13/12/2019
-
2. STUDENTS BUILDING DIDACTIC EXPERIMENTS AS A TOOL FOR TEACHING UNIT OPERATIONS AND PROCESS CONTROL FOR CHEMISTRY TECHNICIANS
The qualified preparation of technician chemistry students who will act directly in the operation and control of industrial chemical plants is a permanent challenge in the teaching-learning process, since such activities require a broad view of the process and a sum of knowledge’s areas such as unit operations, instrumentation and industrial process contro
Quím. Nova. Publicado em: 21/10/2019
-
3. THERMAL PERFORMANCE OF ONE-PASS SHELL-AND-TUBE HEAT EXCHANGERS IN COUNTER-FLOW
Abstract A computational methodology is proposed and applied to calculate the temperature effectiveness, P, and the logarithmic mean temperature difference (LMTD) correction factor, F, of TEMA E shell-and-tube heat exchangers with one-pass and fluids flowing in counter-flow. An arbitrary number of baffles is considered along with three different mixture cond
Braz. J. Chem. Eng.. Publicado em: 30/09/2019
-
4. Comparative Study Between Peristomal Patches in Patients with Definitive Tracheostomy
Abstract Introduction To prevent or diminish pulmonary problems in laryngectomized patients, continuous use of a heat and moisture exchanger (HME) is recommended. Therefore, automatic speaking valves are also often combined with an HME to enable hands-free speech. In order to keep these devices in place, most commonly, peristomal patches are used. Objecti
Int. Arch. Otorhinolaryngol.. Publicado em: 2018-06
-
5. Aqueous Nanofluids Based on Copper MPA: Synthesis and Characterization
The application and use of efficient cooling fluids have become increasingly important due to the increasing industrial and energy demand associated with the miniaturization of various electronic devices. The search for high-efficiency heat exchanger fluids in the early 1990s led to the development of a new class of refrigerants called nanofluids. The use of
Mat. Res.. Publicado em: 11/01/2018
-
6. Dynamic Properties of Coupled Tube-Array Structures with the Axial Loads
Abstract The tube-array structures coupled both with the fluid and the axial load is focused. In a heat exchanger, the tubes are frequently affected by cold and hot fluid shock waves. Thus, tubes are often found to be vibrated and even to be worn out. This vibration may not only alter the performance of the tubes but also introduce the damage in the heat exc
Lat. Am. j. solids struct.. Publicado em: 2016-12
-
7. Application of optimization for improvement of the efficiency of louvered-fin compact heat exchangers
Abstract A few decades ago, the product development process was just based on a trial and error procedure, and the designer's experience. The need for a new way to design and manufacture more economical and sustainable products corroborates increasingly to a new vision of how to create new products for the benefit of society. Modern numerical tools allow gre
REM, Int. Eng. J.. Publicado em: 2016-09
-
8. MULTIVARIABLE OPTIMAL CONTROL OF A HEAT EXCHANGER NETWORK WITH BYPASSES
Abstract Heat exchanger networks present an interesting control problem due to coupling among process streams. In this work, the linear quadratic regulator (LQR), a feedback optimal control technique, is used to control stream temperatures on a laboratory scale heat exchanger network, through bypass manipulation, in a multivariable system. The LQR design was
Braz. J. Chem. Eng.. Publicado em: 2016-03
-
9. Effect of Microstructure on the Thermal Properties of Sintered Iron-copper Composites
Copper is a well know material for use as heat sink or heat exchanger. However, copper has a considerable low tensile strength and temperature limit. A material that has a good thermal conductivity, low cost, but also resistance is the desired. Effects of copper on the sintering and thermal properties of iron-copper composites produced by powder metallurgy a
Mat. Res.. Publicado em: 2015-12
-
10. DETERMINATION OF THE EFFECTIVE RADIAL THERMAL DIFFUSIVITY FOR EVALUATING ENHANCED HEAT TRANSFER IN TUBES UNDER NON-NEWTONIAN LAMINAR FLOW
AbstractEnhanced heat transfer in tubes under laminar flow conditions can be found in coils or corrugated tubes or in the presence of high wall relative roughness, curves, pipe fittings or mechanical vibration. Modeling these cases can be complex because of the induced secondary flow. A modification of the Graetz problem for non-Newtonian power-law flow is p
Braz. J. Chem. Eng.. Publicado em: 2015-06
-
11. DEVELOPMENT OF INSULATING MAGNETIC OIL FOR TRANSFORMERS
The Centrais Elétricas do Norte do Brasil AS – Eletronorte, as well as other companies in the world energy sector, have problems of loss of the performance by excessive heat and even accidents with their transformers. The maintenance and accidents impact of energy supply, generating profit and more expensive insurance premiums. The transformers are essent
Publicado em: 20/07/2014
-
12. Heat transfer to immiscible liquid mixtures in a spiral plate heat exchanger
This work presents new predictive correlations for heat transfer to immiscible liquid-liquid mixtures in a spiral plate heat exchanger. Liquid-liquid heat transfer studies were carried out in spiral plate heat exchangers for the water-octane, water-kerosene, and water-dodecane systems. For each composition of the mixture, the mass flow rate of the cold fluid
Braz. J. Chem. Eng.. Publicado em: 2013-06