Grain Size
Mostrando 1-12 de 466 artigos, teses e dissertações.
-
1. Effect of Multi-Pass Rolling on the Performance of AZ31 Magnesium Alloy Anode in Mg-Air Battery
In this work, the influence of rolling passes on microstructure, corrosion behavior, electrochemical performance, and battery performance of AZ31 magnesium alloy was studied. The experimental results show that the grain size decreases first and then increases with rolling passes. Among them, the grain size of three passes rolled sample is the smallest, while
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
2. Morphology Behavior of Copper Films Deposited after Wet Surface Treatment on Polished Alumina
In this paper, a pre-treatment process for electroless copper (Cu) deposition on the polished alumina (Al2O3) 99.9% and the behavior of Cu plating by electroless process after Al2O3 surface treatment were explored. Our work was carried out by changing the roughness of Al2O3 through micro-etching (coarsening), nucleation its surface by a two-step method (sens
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
3. Microstructure and diametral fracture strength of spark plasma sintered WC-6Co-0.2B and WC-6Co-0.5B ceramic composites from nanosized and metastable WC powders
Abstract The present work aimed at evaluating the microstructures and mechanical properties of spark plasma sintered WC-6 wt% Co ceramic composites doped with boron (0.2 and 0.5 wt%). W-50 at% C (W-6.13 wt% C) powders produced under different milling times (20, 60, 180, and 600 min) were used as starting materials and subsequently mixed with Co (6 wt%) and B
Cerâmica. Publicado em: 2022
-
4. Use of dynamic ballast testing equipment for analysis of rail aggregate breakdown
Abstract The granulometric range used has a direct influence on the life of the ballast layer when subjected to the load generated by rail traffic. However, in Brazil, we have only two size ranges to be used. The publications related to the subject matter under study express the need for a continuous grain size strip, different from the ones usually used in
REM, Int. Eng. J.. Publicado em: 2021-06
-
5. Dolomite-zirconia reaction sintered bonded coarse magnesia ceramics: effect of the bonding proportion
Abstract Refractory ceramic materials were manufactured, mainly composed of magnesia grains (coarse and medium fraction) and CaZrO3/MgO as a binding phase produced from the reaction sintering between CaMg(CO3)2 (dolomite) and m-ZrO2 (monoclinic zirconia), which constituted the finer fraction. Different relationships between the proportion and the size of the
Cerâmica. Publicado em: 2021-06
-
6. Editorial Comment: Luts-V: A new simplified score for assessing lower urinary tract symptoms in men
Abstract Refractory ceramic materials were manufactured, mainly composed of magnesia grains (coarse and medium fraction) and CaZrO3/MgO as a binding phase produced from the reaction sintering between CaMg(CO3)2 (dolomite) and m-ZrO2 (monoclinic zirconia), which constituted the finer fraction. Different relationships between the proportion and the size of the
Int. braz j urol.. Publicado em: 2021-06
-
7. Oxidative Stress & Male Infertility - A necessary and conflicted indissociable marriage: How and when to call for evaluation?
Abstract Refractory ceramic materials were manufactured, mainly composed of magnesia grains (coarse and medium fraction) and CaZrO3/MgO as a binding phase produced from the reaction sintering between CaMg(CO3)2 (dolomite) and m-ZrO2 (monoclinic zirconia), which constituted the finer fraction. Different relationships between the proportion and the size of the
Int. braz j urol.. Publicado em: 2021-06
-
8. Editorial Comment: Vasectomy re-reversal: effectiveness and parameters associated with its success
Abstract Refractory ceramic materials were manufactured, mainly composed of magnesia grains (coarse and medium fraction) and CaZrO3/MgO as a binding phase produced from the reaction sintering between CaMg(CO3)2 (dolomite) and m-ZrO2 (monoclinic zirconia), which constituted the finer fraction. Different relationships between the proportion and the size of the
Int. braz j urol.. Publicado em: 2021-06
-
9. Dysplasia of the fibrous sheath with axonemal and centriolar defects combined with lack of mitochondrial activity as associated factors of ICSI failure in primary ciliary dyskinesia syndrome
Abstract Refractory ceramic materials were manufactured, mainly composed of magnesia grains (coarse and medium fraction) and CaZrO3/MgO as a binding phase produced from the reaction sintering between CaMg(CO3)2 (dolomite) and m-ZrO2 (monoclinic zirconia), which constituted the finer fraction. Different relationships between the proportion and the size of the
Int. braz j urol.. Publicado em: 2021-06
-
10. Influence of sintering parameters on the microstructure and mechanical properties of nanosized 3Y-TZP ceramics
Abstract The fracture toughness of 3Y-TZP ceramics obtained from a nanocrystalline powder with an optimized microstructure and highly transformable tetragonal grains was investigated. Samples of ZrO2-3 mol% Y2O3 were sintered at temperatures between 1250 and 1400 °C, with isothermal holding times of up to 16 h. Samples sintered at 1250 °C exhibited relativ
Cerâmica. Publicado em: 2021-03
-
11. Cold sintering and electric characterization of ZnO-BaTiO3 composites
Abstract The sintering is an essential step in the processing of ceramics materials. A number of researchers have reported new techniques for sintering. However, in general, the process still demands high temperatures. This paper reports the results of the cold sintering of ZnO-BaTiO3 composites. The microstructural, structural, and electric properties of th
Cerâmica. Publicado em: 2021-03
-
12. Inoculation of rhizobia increases lima bean (Phaseolus lunatus) yield in soils from Piauí and Ceará states, Brazil
ABSTRACT The inoculation of rhizobia in lima bean can increase its yield and contribute to smallholder farms. In this study, the potential of rhizobia in increasing the lima bean yield was evaluated in two regions from Piaui and Ceará states. The experiments were conducted in field comparing three rhizobia strains (UFPI32, UFPI38, UFPI59), one strain of ref
Rev. Ceres. Publicado em: 2020-10