Frequency Inverter
Mostrando 1-12 de 28 artigos, teses e dissertações.
-
1. Green Energy Generation Using FLC Based WECS With Lithium Ion Polymer Batteries
ABSTRACT Green Energy Generation Using Wind energy conversion system is achieved using Lithium Ion Polymer Batteries and Fuzzy logic controller. Presented scheme also provides the constant output power for the stand alone loads like Island, Hills Stations, Ships and Remote locations etc. A fuzzy-logic controller based Wind energy conversion system with perma
Braz. arch. biol. technol.. Publicado em: 23/01/2017
-
2. Sistemas inteligentes para monitoramento e diagnósticos de falhas em motores de indução trifásicos / Intelligent systems for faults monitoring and diagnosis in three-phase induction motors
The objective of this thesis consists of the implementation of intelligent systems for three-phase induction motors fault diagnosis and condition monitoring. Therefore, an experimental test stand for stator winding inter-turn short circuit faults, broken rotor bar in squirrel cage and, finally, defective wheel bearing has been designed. The main focus is to
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 11/04/2012
-
3. Desenvolvimento de software para parametrização, monitoramento e supervisão de conversores de frequência / Development of software for parameterization, monitoring and supervision of frequency converters
A utilização de software supervisório é fundamental na automação de processos de diversas áreas, como indústria automotiva, robótica, agrícola, entre outros. Estes softwares supervisórios devem refletir as operações de diferentes tipos de sensores e atuadores. A maioria dos softwares supervisórios são proprietários, ou seja, possuem protocolo
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 31/05/2011
-
4. âUma Proposta de Projeto Para Inversor MultinÃvel em Cascata AssimÃtrico com 63 NÃveis na TensÃo de SaÃda e OperaÃÃo em Baixa FrequÃnciaâ / "Design Proposition For a 63 Levels Output Voltage Asymmetric Multilevel Cascaded Inverter at low Frequency Operation"
This dissertation proposes a design of a cascaded multilevel inverter using H-bridge cells in asymmetric configuration and a multiple secondary transformer. Equations for determining the frequency operation of each cell with binary and ternary configurations, as well as the complete design of toroidal transformer with laminated core. This work proposes also
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 11/02/2011
-
5. Application of adaptive control in a refrigeration system to improve performance
This paper reports an experimental investigation using adaptive control in a refrigeration system. This system is composed basically of a semi-hermetic compressor, concentric tubes heat exchangers, the condenser and evaporator, and thermostatic expansion valve (TXV). The refrigerant used in the refrigeration system was the HCFC-22 and also an AC frequency in
Journal of the Brazilian Society of Mechanical Sciences and Engineering. Publicado em: 2011-06
-
6. Conversor CC/CA de alta freqüência baseado em inversores ressonantes com comutação seqüencial para excitação de uma tocha indutiva a plasma térmico
This work describes the study, the analysis, the project methodology and the constructive details of a high frequency DC/AC resonant series converter using sequential commutation techniques for the excitation of an inductive coupled thermal plasma torch. The aim of this thesis is to show the new modulation technique potentialities and to present a technologi
Publicado em: 2010
-
7. Projeto de filtros para atenuação de correntes de modo comum e de sobretensões em acionamentos de motores elétricos utilizando inversores PWM
The use of inverters in most of electrical motor drives applications has been accompanie by several undesirable effects, such as overvoltage at the motor terminals, circulation of common mode currents and electromagnetic interference problems. The determining factors for most of these problems come with the high switching speed and frequency of the semicondu
Publicado em: 2010
-
8. Study of a cooling system with air forced with monitoring of electrical energy consumption / Estudo de um sistema de resfriamento com ar forçado com monitoramento do consumo de energia eletrica
This work is a study of a classical controller implementation using tuning method referred to as IMC (Internal Model Control), aimed at reducing electrical energy consumption that proceed the appropriate relation between this consumption and cooling time of the cooling process with forced air. For this, the supervisory system installed is able to manipulate
Publicado em: 2010
-
9. Three cell flying capacitor inverter for dielectric barrier discharge plasma applications
It is reported the design, construction and initial tests of a three cell flying capacitor inverter (TCFCI) in a half-bridge configuration. The device operates at a 200 kHz frequency which leads to a voltage output at 12.5 kHz presenting an acceptable response in an open-loop configuration. These features outdo those reported in the current multilevel conver
Brazilian Journal of Physics. Publicado em: 2009-06
-
10. Inversor monofásico sincronizado para a conexão de um gerador eólico à rede elétrica : estudo, projeto e implementação
The aims of this work are the study, design and implementation of a dc/ac converter for the connection of a wind power generator to the electric grid. It makes use of a single-phase inverter, with three-level PWM modulation, connected to the grid through a low frequency transformer. Three distinct variables are controlled in the converter: the output current
Publicado em: 2009
-
11. PROJECT, IMPLEMENTATION AND AUTOMATION OF A BENCH FOR TESTING SWITCHED RELUCTANCE MOTORS / PROJETO, IMPLEMENTAÇÃO E AUTOMAÇÃO DE UMA BANCADA PARA ENSAIOS DE MOTORES A RELUTÂNCIA CHAVEADOS
This work presents a proposal for testing Switched Reluctance Motors, which is feasible by the design and construction of an automated test bench. The test proposal intends to measure phases resistance; to compute copper loss; to obtain the magnetizing curves for aligned and unaligned rotor and a performance test, which is based on fixing the under test moto
Publicado em: 2009
-
12. CONTRIBUTION TO THE CONTROL OF ELECTRODYNAMIC VIBRATION MACHINES / CONTRIBUIÇÃO AO CONTROLE DE MÁQUINAS DE VIBRAÇÃO ELETRODINÂMICAS
This work presents contributions to the sinusoidal acceleration control of electrodynamic shakers applied in vibration testing. Considering the importance of sine tests to identify critical frequencies of operation and to determine mechanical weakness in the specified performance of specimens, vibration controllers are designed to reproduce the amplitude and
Publicado em: 2009