Desulfurization
Mostrando 1-12 de 70 artigos, teses e dissertações.
-
1. Steel desulfurization on RH degasser: physical and mathematical modeling
Abstract Due to the high-quality steel demand, especially for ultra-low Sulfur steel, RH desulfurization has been practiced. Based on this, mathematical and physical modeling have been applied to study steel desulfurization by reagent addition in the RH degasser vacuum chamber. The main result of cold modeling, using water and oil emulating steel and slag, r
REM - International Engineering Journal. Publicado em: 2022
-
2. Influence of bottom ash and red mud additions on self-leveling underlayment properties
Abstract Self-levelling underlayments (SLUs) based on Portland cement (PC) are susceptible to cracking due to drying shrinkage. The present study evaluated the influence of binder contents on systems consisting of calcium aluminate cement (CAC), PC, and a source of calcium sulfate (C$), derived from the flue gas desulfurization process (FGD), on the mechanic
Cerâmica. Publicado em: 2022
-
3. FAST DETERMINATION OF THE SULFUR SPECIES IN SOLID PHASE SYSTEMS BY A TPO-IR METHOD
Qualitative and quantitative assessment of total sulfur and sulfur species in solid phase is necessarily important for development of effective desulfurization methods, reduction of environmental pollution, and prevention of catalyst poisoned. In this work, TPO-IR (Temperature Programmed Oxidation- Infrared) method was used for rapid determination of sulfur
Quím. Nova. Publicado em: 2021-01
-
4. DEEP EUTECTIC SOLVENTS BASED ON BETAINE AND PROPYLENE GLYCOL AS POTENTIAL DENITRIFICATION AGENTS: A LIQUID-LIQUID EQUILIBRIUM STUDY
Abstract Two deep eutectic solvents (DES) based on betaine (B) and propylene glycol (PG) in molar ratios of 1:4 and 1:5 were prepared and their physico-chemical properties were determined. Liquid-liquid equilibria at 298.15 K and atmospheric pressure were determined for 13 quasi-three-component systems with a hydrocarbon (n-hexane, n-heptane, i-octane or tol
Braz. J. Chem. Eng.. Publicado em: 13/01/2020
-
5. SEPARATION OF SULFUR-CONTAINING COMPOUNDS FROM DIESEL BY OXIDATION FOLLOWED BY SOLVENT EXTRACTION IN A SINGLE DROP COLUMN
Abstract Oxidative desulfurization (ODS) is an attractive complementary or alternative process for the hydrodesulfurization (HDS) process due to advantages such as mild operating conditions. In the ODS process, the sulfur-containing compounds are oxidized first to polar sulfoxide and sulfone products and then these polar compounds are separated using solvent
Braz. J. Chem. Eng.. Publicado em: 09/12/2019
-
6. SYNTHESIS OF MORPHOLINE-BASED IONIC LIQUIDS FOR EXTRACTIVE DESULFURIZATION OF DIESEL FUEL
Abstract Extractive desulfurization with ionic liquids has attracted significant attention from a growing number of scientists due to the current environmental restrictions on fuel. Protic ionic liquids (PILs) were synthesized via equimolar neutralization of morpholine and formic-based compounds. The obtained PILs were characterized by Fourier transform infr
Braz. J. Chem. Eng.. Publicado em: 30/09/2019
-
7. Aplicação de processo adsortivo para dessulfurização de combustíveis utilizando fibra de coco como adsorvente
RESUMO A presença de compostos orgânicos contendo enxofre nos combustíveis é um dos contribuintes da poluição atmosférica, pois quando entram em combustão nos motores, emitem poluentes derivados do enxofre, como os óxidos (SOx), que afetam negativamente a saúde humana e o meio ambiente. A remoção do excesso de enxofre presente na gasolina pode se
Matéria (Rio J.). Publicado em: 16/09/2019
-
8. Pyrite utilization in the carboniferous region of Santa Catarina, Brazil - Potentials, challenges, and environmental advantages
Abstract The main coal seams explored in the coal region of Santa Catarina are Barro Branco (BB) and Bonito (BO). Owing to the association with the mineral matter, the tailings generated in the beneficiation are arranged in disposal areas, and subject to the generation of acid mine drainage (AMD). The objective of this study was to evaluate the use of pyrite
REM, Int. Eng. J.. Publicado em: 19/06/2019
-
9. Replacement of fluorspar in the desulfurization of hot metal
Abstract In the steel industry, lime is used as a desulfurizing agent and fluorspar as flux in the hot metal desulfurization process. However there are environmental concerns regarding the use of fluorspar, even when its harmful effects are not fully known. In order to reduce such risks and also to anticipate possible future restrictions, which could undermi
REM, Int. Eng. J.. Publicado em: 2018-04
-
10. Development of Synthetic Slag with Marble Waste and Calcium Aluminate Agents for Cast Iron Desulfurization
The aim of this work was to study the use of slags to desulfurize cast iron. It was proposed to use alumina instead of fluorspar. In addition, marble waste was used instead of lime. Simulations applying Thermo-Calc® software were carried out in order to obtain the theoretical phases using thermodynamic data. Then, a comparison between theoretical data and e
Mat. Res.. Publicado em: 13/07/2017
-
11. EVALUATION OF LIMESTONE IMPURITIES IN THE DESULFURIZATION PROCESS OF COAL COMBUSTION GAS
Abstract Limestones have been used to capture SO2 emitted during the combustion of coal for decades. However, due to the complexities of the variables involved in this process, many issues are still being studied. Some tests were performed in a fluidized bed reactor, which was used to evaluate the performance of the limestones in the bed for flue gas desulfu
Braz. J. Chem. Eng.. Publicado em: 2017-01
-
12. Oxidative Desulfurization of Gasoline by Ionic Liquids Coupled with Extraction by Organic Solvents
In this work, desulfurization of real fluidized catalytic cracking (FCC) gasoline was investigated in dual steps; first in oxidative desulfurization (ODS) using imidazolium and pyrrolidonium based Brønsted acidic ionic liquids (ILs) as solvent and catalyst and hydrogen peroxide as oxidant. In second step, extractive desulfurization took place using organic
J. Braz. Chem. Soc.. Publicado em: 2016-06