Confocal Laser Scanning Microscopy
Mostrando 13-24 de 342 artigos, teses e dissertações.
-
13. Biocorrosion on Surface of ASTM A283 Carbon Steel, Exposed in Diesel S10 and Tap Water
This paper sets out to evaluate the corrosion and biocorrosion of carbon steel ASTM A283 exposed to a Diesel S10 oil/tap water system under static conditions for 90 days. The following analyzes were performed: physico-chemical in tap water, sulfur content in Diesel S10 and quantification of sessile microorganisms in the biofilm formed on the metal. To monito
Mat. Res.. Publicado em: 22/01/2018
-
14. Influence of the Tungsten Content on Surface Properties of Electroless Ni-W-P Coatings
Ternary Ni-W-P films were produced by electroless deposition using baths with different tungsten concentrations. After deposition, the coated surfaces were annealed at 400°C for 1h. Surface morphology and film composition in the as-plated condition were assessed by SEM and EDS analyses, respectively. The crystalline phases after annealing were investigated
Mat. Res.. Publicado em: 21/11/2017
-
15. Electrochemical Study of the AISI 409 Ferritic Stainless Steel: Passive Film Stability and Pitting Nucleation and Growth
The aim of the present work was to study the passive film stability and pitting corrosion behavior of the AISI 409 stainless steel. The electrochemical tests were carried out in 0.1 M NaCl solution at room temperature. The general electrochemical behavior was assessed using electrochemical impedance spectroscopy (EIS) measurements whereas the semiconducting
Mat. Res.. Publicado em: 18/09/2017
-
16. Confocal Fluorescence Microscopy and Kinetics of the Cr 3+-Chromate Ion Oxidation Equilibria at the Solid Liquid Interface
Silica-borax pearl samples impregnated with 0.17 and 0.64% Cr3+ were characterized by specific surface area measurements, UV-Vis spectroscopy, energy-dispersive X-ray fluorescence and laser-scanning confocal microscopy. Pearl stability against oxidizing conditions was tested by adding samples to an aqueous hydrogen peroxide solution. The reaction was examine
J. Braz. Chem. Soc.. Publicado em: 2017-09
-
17. Effect of photodynamic therapy and non-thermal plasma on root canal filling: analysis of adhesion and sealer penetration
Abstract Objective The aim of this study was to evaluate the effect of photodynamic therapy (PDT) and non-thermal plasma (NTP) on adhesion and sealer penetration in root canals. Material and Methods Sixty single-rooted premolars were used. The teeth were prepared using a crown-down technique. NaOCl and EDTA were used for irrigation and smear layer remova
J. Appl. Oral Sci.. Publicado em: 2017-08
-
18. Growth, viability and architecture of biofilms of Listeria monocytogenes formed on abiotic surfaces
Abstract The pathogenic bacterium Listeria monocytogenes can persist in food processing plants for many years, even when appropriate hygienic measures are in place, with potential for contaminating ready-to-eat products and, its ability to form biofilms on abiotic surfaces certainly contributes for the environmental persistence. In this research, L. monocyto
Braz. J. Microbiol.. Publicado em: 2017-07
-
19. Effect of La 0.8 Sr 0.2 MnO 3 powder addition in the precursor solution on the properties of cathode films deposited by spray pyrolysis
ABSTRACT Films of lanthanum strontium manganite, LSM (La0.8Sr0.2MnO3) were deposited on yttria stabilized zirconia (YSZ) substrates by different methods aiming to establish the most suitable route to prepare cathodes for solid oxide fuel cells (SOFC). Samples were obtained by using a solution of lanthanum, strontium and manganese nitrates or a dispersion of
Matéria (Rio J.). Publicado em: 11/05/2017
-
20. Influence of root dentin treatment on the push-out bond strength of fibre-reinforced posts
Abstract This study evaluates the influence of root dentin treatment with NaOCl alone and combined with EDTA, with and without ultrasound activation, on the push-out bond strength (BS) of fiber-reinforced posts in weakened roots, cemented with RelyX or Panavia. The root canals of 42 maxillary canines were instrumented with Reciproc and 2.5% NaOCl. In the cor
Braz. oral res.. Publicado em: 10/04/2017
-
21. The effect of standardised implantoplasty protocol on titanium surface roughness: an in-vitro study
Abstract: To analyse the changes of surface characteristics of machined and moderately roughened titanium disks following a standardised implantoplasty protocol. Forty titanium discs (machined: n = 20; moderately roughened: n = 20) were instrumented with one half of each disc maintained as the control (non-instrumented). The standardised implantoplasty proto
Braz. oral res.. Publicado em: 22/12/2016
-
22. Effect of ultrasonic streaming on intra-dentinal disinfection and penetration of calcium hydroxide paste in endodontic treatment
ABSTRACT Objective The antimicrobial effect of ultrasonic agitation of calcium hydroxide (CH) pastes in infected bovine dentin and their penetrability were evaluated using confocal laser scanning microscopy (CLSM) and microbiological culture. Material and Methods Fifty-two bovine teeth were infected with Enterococcus faecalis using a new contamination pr
J. Appl. Oral Sci.. Publicado em: 2016-12
-
23. Exopolysaccharide dispelled by calcium hydroxide with volatile vehicles related to bactericidal effect for root canal medication
ABSTRACT Objective: Enterococcus faecalis is the dominant microbial species responsible for persistent apical periodontitis with ability to deeply penetrate into the dentin. Exopolysaccharides (EPS) contribute to the pathogenicity and antibiotic resistance of E. faecalis. Our aim was to investigate the antimicrobial activity of calcium hydroxide (CH), camph
J. Appl. Oral Sci.. Publicado em: 2016-10
-
24. Evaluation of skin absorption of drugs from topical and transdermal formulations
ABSTRACT The skin barrier function has been attributed to the stratum corneum and represents a major challenge in clinical practice pertaining to cutaneous administration of drugs. Despite this, a large number of bioactive compounds have been successfully administered via cutaneous administration because of advances in the design of topical and transdermal f
Braz. J. Pharm. Sci.. Publicado em: 2016-09