PM versus IM Ti-5Al-5V-5Mo-3Cr Alloy in Mechanical Properties and Fracture Behaviour

AUTOR(ES)

Zhao, Qinyang

FONTE

Mat. Res.

DATA DE PUBLICAÇÃO

27/06/2019

RESUMO

The comparisons of mechanical properties and fracture behaviour between as-consolidated PM Ti-5553 alloy and as-cast IM Ti-5553 alloy were investigated through tensile, fracture toughness and impact toughness tests in this research. The slightly higher strength but much higher ductility and toughness can be identified in IM alloy specimens, which is also confirmed by the fracture behaviour of the specimens after mechanical tests. IM alloy specimens always exhibit the ductile dimple fracture mechanism in the different tests, while the fracture mechanism of PM alloy specimens indicates a high loading rate sensitivity, changing from the mixed ductile-brittle quasi-cleavage fracture into the brittle cleavage fracture mechanism accompanied by the remarkable decrease of impact toughness. The relatively low mechanical properties, especially the ductility and the brittle fracture behaviour of as-consolidated PM Ti-5553 alloy, are mainly explained by the differences in the initial microstructures between these two alloys.

Documentos Relacionados

• Effect of heat treatment on microstructures and mechanical properties in a full lamellar PM TiAl alloy
• Microstructure and transformation characteristics of a TiAlNb alloy with Cr and Mo addition
• The influence of Nano-TiO2 and Nano-Al2O3 Particles in Silicate Based Electrolytes on Microstructure and Mechanical Properties of Micro Arc Coated Ti6Al4V Alloy
• Microstructural Adjustments and Tensile Properties of a Hot-Forged Ti−22Al−23Nb−3V−Y Alloy
• Study of Mechanical and Wear Behaviour of Hyper-Eutectic Al-Si Automotive Alloy Through Fe, Ni and Cr Addition