Investigation of various factors affecting encapsulation on the In-Cap automatic capsule-filling machine

AUTOR(ES)
FONTE

Springer-Verlag

RESUMO

The purpose of this study was to determine the factors that influence fill weight and weight variability of capsules produced on the In-Cap and to assess any differences in terms of capsule defects between gelatin and HPMC (Quali-V) shells. The In-Cap is an automatic tamping type capsule-filling machine and the low output of ≈3000 capsules/hour makes it ideal for early formulation development and phase I/IIa clinical supplies manufacture. Four commonly used excipients (Avicel PH101, Avicel PH302, A-Tab, and Prosolv HD90) and a poorly flowing drug blend were encapsulated at various pin settings and powder bed heights. The average fill weight and coefficient of weight variation were determined. The percentage of defective capsules formed during encapsulation was calculated. Results of the study showed that pin setting was critical for controlling the fill weight and the weight variation. The order of pin setting with pin 1 (closer to the powder chute) set to a relatively higher position and pin 4 (before ejection) set to a lower position was found to give higher fill weights with relatively lower weight variability. The powder bed height influenced the fill weight for poorly flowing powders. The capsule machine speed did not appear to significantly influence the fill weight. The fill weight and weight variation were found to depend on the flow property of the material. A large percentage of defective capsules was obtained using HPMC shell size #00. Some of the commonly observed defects included split caps and improperly closed filled capsules. In general, appropriate selection of pin settings and bed height can reduce the weight variability seen, especially with poorly flowing high-dose formulations.

ACESSO AO ARTIGO

Documentos Relacionados