Efeito da mesogeometria da broca e das condições de lubrirrefrigeração sobre o acabamento do furo em aço ARBL DIN S700MC

AUTOR(ES)
FONTE

Matéria (Rio J.)

DATA DE PUBLICAÇÃO

20/05/2019

RESUMO

RESUMO O trabalho apresenta um estudo sobre os efeitos decorrentes da modificação da mesogeometria de uma broca helicoidal de metal-duro com revestimento de TiAlN sobre o acabamento superficial do aço de alta resistência e baixa liga DIN S700MC utilizando diferentes condições de aplicação de fluidos lubrirrefrigerantes (em abundância, em mínima quantidade e a seco). Para tanto, foram consideradas como variáveis de resposta a rugosidade do furo, o dimensional da rebarba gerada e a camada afetada pelo calor. Os resultados mostram que a utilização da broca com mesogeometria alterada gerou uma redução dos valores de rugosidade, maior valor dimensional da rebarba gerada e maiores valores de modificação microestrutural pelo calor. Com relação aos meios lubrirrefrigerantes, os resultados de rugosidade não foram influenciados pelas diferentes condições de aplicação; o fluido em abundância, juntamente com a broca sem modificação, apresentou os menores valores de rebarba; não houve variações expressivas entre a aplicação do fluido em abundância e em mínima quantidade na análise da camada afetada pelo calor.ABSTRACT This paper presents an investigation on the behavior and effect of the machining process by drilling through a DIN S700MC steel alloy, correlating the preparation of cutting-edge geometry with different coolinglubrication conditions, and focusing on the surface finishing of the machined part. In this context, experimental tests were performed with different cooling-lubrication systems (abundance, MQL, and dry) using solid carbide twist drills, coated with titanium aluminum nitride, with or without meso-geometry preparation (roundings). As response variables were assessed the texture (roughness), the layer affected by heat throughout the hole and burr dimensional profiles. The results indicate a significant reduction of roughness values when using the rounding drill flank, face and guides. Statistically, this result was not influenced by the different cooling-lubrication systems. Regarding burr dimension generated by the process, the tool with no meso-geometry preparation presented the same values along with the application of fluid in abundance (emulsion). In the analysis of the layer affected by heat, the tool with meso-geometry preparation presented lower values of the affected layer (microstructure change) and, statistically, there were no significant variations between the application of fluid in abundance and with MQL.

Documentos Relacionados