Determinação de níveis ótimos de passividade em prótese sobre implante em função da deformação dos intermediários / Optimum passivity levels of implant prosthesis according to abutment deformation

AUTOR(ES)
DATA DE PUBLICAÇÃO

2007

RESUMO

Passive fit has been considered one of the most important requirements for the success of implant supported prostheses. This in vitro study investigated the abutment deformation of an implant-supported prosthesis after screw tightening of palladium-silver and cobalt-chromium prosthetic cylinder. A master model was used to simulate a human mandible with five implants. The Strain gauges were attached on the sides of each abutment to capture deformations because of the cylinders screws after was tightened. The abutments were mounted onto implant replicas and the screws were tightened to a 20 Ncm torque, and the readings were recorded. After this step, palladiumsilver and cobalt-chromium prosthetic cylinders were tightened to a 10 Ncm torque and the readings were recorded. The measurements were repeated five times. Mann-Whitney statistical test was applied to the results. No statistical differences were found between the deformation generated by palladium-silver and cobalt-chromium prosthetic cylinders. However, there were differences relative to the quality of the strain. The deformation generated by screw tightness of the cobalt-chromium prosthetic cylinders was compressive while palladium-silver prosthetic cylinders generated compressive and tensile strain.

ASSUNTO(S)

passive fit assentamento passivo strain gauges extensômetros

ACESSO AO ARTIGO

Documentos Relacionados