Avaliação energética de um edifício de serviços: Escola Superior Aveiro Norte, Portugal

AUTOR(ES)
FONTE

Ambient. constr.

DATA DE PUBLICAÇÃO

03/10/2019

RESUMO

Resumo O objetivo deste trabalho é realizar uma avaliação energética da Escola Superior Aveiro Norte (ESAN), situada no município de Oliveira de Azeméis (Portugal). Esse edifício possui tecnologias de climatização pouco convencionais em Portugal, como bombas de calor geotérmicas associadas a piso radiante e ventilação, com pré-aquecimento de ar, utilizando painéis solares e recuperação de calor. Apesar de visarem a melhoria das condições de conforto térmico com baixo consumo energético, podem não garantir essas condições. Modela-se o edifício com a ferramenta computacional de simulação dinâmica DesignBuilder, introduzindo-se dados relativos a envoltória, iluminação, ocupação, equipamentos e sistemas de climatização. A partir da modelização do edifício e da análise dos resultados, verificou-se que a heterogeneidade da área de superfícies envidraçadas e das cargas térmicas entre os diferentes espaços internos, conjugados com a climatização feita por três sistemas partilhados de aquecimento, ventilação e ar condicionado, causa grandes desequilíbrios térmicos e dificuldades em garantir condições de conforto térmico no edifício. Este estudo poderá ser aplicado em outras tipologias de edifícios, especialmente aqueles situados em regiões com grandes amplitudes térmicas diárias e/ou sazonais, com necessidades de aquecimento e arrefecimento. Além disso, demonstra-se que, com bom planejamento, é possível projetar edifícios com eficiência energética e conforto térmico.Abstract The goal of this paper is to undertake an energy performance analysis of the North Aveiro School (ESAN) building, located in the municipality of Oliveira de Azeméis (Portugal). This building uses HVAC technologies that are unusual in Portugal, such as ground source heat pumps associated with floor heating and ventilation with air preheating, using solar panels and heat recovery. Although these technologies were intended to provide thermal comfort conditions with low energy consumption, they have failed to do so. A thermal dynamic simulation of the building was made using the DesignBuilder software, including features such as envelope, lighting, occupancy, equipment and HVAC systems. Based on the building model and the analysed results, the researchers found that the heterogeneity of the glazed surfaces, the the differences in thermal loads in the different rooms, and the three shared cooling systems cause major thermal imbalances and difficulties to provide thermal comfort conditions in the building. This study can be applied to other buildings, especially buildings located in regions with broad daily and/or seasonal thermal amplitudes, which need both heating and cooling. This study is important because it demonstrates that with good planning, it is possible to design buildings with energy efficient thermal comfort strategies.

Documentos Relacionados