Aluminum
Mostrando 13-24 de 1508 artigos, teses e dissertações.
-
13. Evaluation of the combined addition of aluminum lactate and calcium carbonate to alumina-based castables
Abstract Calcium aluminate cement (CAC) can induce the development of high green mechanical strength to refractory castables in a short period of time (24 h). However, the production of this hydraulic binder is energy-intensive and releases a large content of carbon dioxide (CO2), which adds to global warming. Thus, aiming to develop an alternative binding s
Cerâmica. Publicado em: 2021-06
-
14. Silicon carbide hollow fiber membranes developed for the textile industry wastewater treatment
Abstract In order to reduce the impacts of the industrial effluent on the environment, silicon carbide hollow fiber membranes were prepared by the precipitation-immersion technique and sintered at 1450 and 1500 °C. The membranes were characterized by X-ray diffraction, their surface structure was characterized by scanning electron microscopy and atomic forc
Cerâmica. Publicado em: 2021-06
-
15. A SIMPLE GREEN REDUCTION STRATEGY TO SUBSTITUTE CADMIUM IN ANALYTICAL REDUCTION OF NITRATE IN GRIESS–ILOSVAY METHOD
Nitrate is an abundant ion that is present in many industrialized products and the environment. Various analytical methods have been described using the Griess-Ilosvay reagent for the determination of nitrate in different matrices after its reduction to nitrite, in most cases with metallic cadmium as the reducer. This work proposes a new method using aluminu
Quím. Nova. Publicado em: 2021-02
-
16. Synthesis, Characterization and Exchange Reactions of Layered Double Hydroxides of Copper and Aluminum, Intercalated with Sulfate
Layered double hydroxides (LDHs) of Cu:Al in the molar ratio of 2:1, intercalated with sulfate, sulfate/(Li+, Na+, K+ or NH4+), NO3- and CO32-, were synthesized by co-precipitation with increasing pH. The materials were submitted to exchange reactions using B2SO4 (B = Li+, Na+, K+, NH4+) solutions in an attempt to replace previously intercalated cations or i
J. Braz. Chem. Soc.. Publicado em: 2021-01
-
17. On the effect of interrupted ageing (T6I4) on the mechanical properties of AA6351 and AA7050 alloys
Abstract The mechanical properties of age-hardenable aluminum alloys are strongly influenced by the volume fraction, size and spacing of hardening precipitates. In addition, researches have shown that interrupted ageing (T6I4) could benefit the hardening response of these alloys. Interrupted ageing is a term generally used for the microstructural developmen
REM, Int. Eng. J.. Publicado em: 2021-01
-
18. Design, Synthesis, and Application of Colored Cobalt Pigments (Pink, Blue, Green)
The combination of white or colorless oxides (MgO, Al2O3, ZnO) with colorant ions (Co2+) generates colored pigments (pink, blue, green). The color is caused by the insertion of the colorant ion in the respective crystal lattices (periclase, alumina, wurtzite), as verified by X-ray diffraction. Absorption spectra in the visible region show analogous triplet b
J. Braz. Chem. Soc.. Publicado em: 2020-11
-
19. ENVIRONMENTAL THERMAL COMFORT OF A REDUCED MODEL USING CROSS-LAMINATED TIMBER
ABSTRACT The challenges for the use of the cross-laminated timber (CLT) system in the Brazilian agricultural market are significant. This study evaluated the thermal performance of fiber cement tiles associated with a CLT non-conventional structure compared to those of ceramic, fiber cement and aluminum roof tiles based on following thermal comfort indexes (
Eng. Agríc.. Publicado em: 2020-08
-
20. Catalytic Dehydration of Glycerol to Acrolein over Aluminum Phosphate Catalysts
Gas phase conversion of glycerol to acrolein over a variety of aluminum phosphate (AlP) catalysts synthesized by a simple replacement reaction method with a variation in calcination temperature (300-700 ºC, AlP-300, AlP-400, AlP-500, AlP-600, and AlP-700, respectively) has been investigated. The textural properties, acidities and coke contents of the sample
J. Braz. Chem. Soc.. Publicado em: 2020-08
-
21. NEGATIVE EFFECTS ON PHOTOSYNTHESIS AND CHLOROPLAST PIGMENTS EXPOSED TO LEAD AND ALUMINUM: A META-ANALYSIS
ABSTRACT Toxic metals have become some of the main abiotic agents that influence the stress of organisms due to their numerous agricultural and industrial uses that result in bioaccumulation and toxicity at different levels, depending on the type and concentration in the environment. Aluminum and lead are present as a result of anthropogenic activities and c
CERNE. Publicado em: 2020-06
-
22. DIAGNOSIS AND SPATIAL VARIABILITY OF SOIL FERTILITY AND CROP PRODUCTION IN A TEAK AREA IN EASTERN PARÁ STATE.
ABSTRACT This study aims to generate the diagnosis and spatial variability maps of soil fertility attributes, as well as teak (Tectona grandis L.f.) production through geostatistics. The study was conducted on a commercial farm in the municipality of Capitão Poço, state of Pará, Brazil. Soil and yield data were collected from 155 sampled georeferenced poi
CERNE. Publicado em: 2020-03
-
23. Renal osteodystrophy and clinical outcomes: data from the Brazilian Registry of Bone Biopsies - REBRABO
RESUMO Introdução: Os distúrbios minerais e ósseos (DMO) são importantes complicações da doença renal crônica (DRC) associadas à desfechos adversos. O Registro Brasileiro de Biópsia Óssea (REBRABO) é um banco de dados eletrônico que inclui dados sobre osteodistrofia renal (OR). Nosso objetivo foi descrever o perfil epidemiológico da OR em uma
J. Bras. Nefrol.. Publicado em: 20/01/2020
-
24. Effects of Geometrical Feature on Microstructures and Mechanical Properties of Refill Friction Stir Spot Welding 6061 Aluminum Alloy
Refill friction stir spot welding (refill FSSW) is a solid state joining technology developed and patented by Helmholtz-Zentrum Geesthacht. Refill FSSW is a welding process suitable for spot joining lightweight materials in similar and dissimilar joint configuration. The result is a spot welded in lap configuration with minimal material loss and a flat surfa
Mat. Res.. Publicado em: 17/01/2020